| 
Qualcomm Cell Phone Car Holder Installation
| |
- Place the two vent clips
into the slotted area on the back of the base of the cell phone
holder. Slide one to the left of center and one to the right.
- These clips are adjustable
to be used with any kind of air vent slots. In air vents that
have horizontal slats you can use the lower brace to help hold
your cellular phone steady. If you have vertical vents, this
step may not be necessary.
- Carefully line up the
the two vent clips with the slats in your vent and press until
you feel and hear them click into place. Only a moderate amount
of pressure should be necessary for this.
- Wipe the back of your
phone off with a very small amount of rubbing alcohol to remove
any oil residue or dust. Remove the 3M sticker from the Magnetic
Sticker, being careful not to leave fingerprints. (oils and
dust will impair the strength of the adhesive)
- Place the magnetic sticker
to the back of your Qualcomm cell phone or cell phone battery.
You won't have to remove your phone from it's carrying case
because this magnet is strong enough to connect through it!
|
If
you don't see your QUALCOMM cellular
phone or cellular phone accessory listed above, please send us an email
at: info@88-cellular.com.
QUALCOMMM is a registered
trademark of QUALCOMM INCORPORATED. Its use in connection with merchandise
offered for sale herein is intended only to indicate the compatibility
of the product with the trademarked item. It in no way is intended to
indicate affiliation with, or endorsement by the owner of the trademark.
|
